Failure due to vibration

This is an area for those new to clutches and brakes. We encourage posts on general selection, construction, and operation.
Posts: 1
Joined: Fri Jun 07, 2019 8:34 am

Failure due to vibration

Postby tomc » Fri Jun 07, 2019 8:40 am

I have a clutch on a riding mower. When it failed, I was told it due to vibration and that it had a 'bobbin coil". Does this sound plausible? What is a bobbin coil? Is there are better coil to use for this application? Any input would be appreciated.

Posts: 49
Joined: Tue Nov 07, 2017 12:23 pm

Re: Failure due to vibration

Postby Taylor » Mon Aug 05, 2019 11:47 am

Clutches fitted for outdoor equipment typically have a wound coil that is potted. It seals out contaminants. It keeps the coil from bouncing all over the place too.

The electromagnetic clutches used on riding mowers are pretty rugged. Perhaps someone replaced the original clutch with some inferior type to try and save a few bucks. :roll:

Who is online

Users browsing this forum: No registered users and 0 guests